New for 2010
James Cotta's street driven drag racers/auto cross p/u
(story to be added soon)

Step 1
prepping truck and removing parts

Step 2
getting measurements for ride height and rake angle correct

Step 3
set up on the chassis table

Step 4
starting the chassis fabrication

Step 5
setting the cab for fitting and cab mounts

Step 6
remove wiring, dash, steering column and peddles

Step 7
fabricate roll cage and weld in

Step 8
fabricate front strut tubes and strut mounts

Step 9
start fabrication on rear half of chassis

Step 10
fabricate rear mounting brackets, set up and machine housing

Step 11
fabricate coil over mounts to frame

Step 12
cut bed floor out, mount bed to frame and start on wheel tubes

Wheel tubs